Gigabyte GA-X58A-UD3R User Manual page 103

Now, you may proceed to create the SATA driver diskette (for AHCI mode) and the installation of the SATA
driver and operating system.
Delete the RAID Array:
To deleted the existing array, select the array on the main menu (example: VD 0: New_VD) and press <En-
ter> to display the Delete option. Press <Enter>. When prompted, press <Y> to confirm or <N> to cancel (Figure
8).
Topology
HBA 0 : Marvell 0
Virtual Disks
VD 0: New_VD
PD 0: WDC WD800JD-22L
PD 0: WDC WD800JD-22L
Free Physical Disks
Help
Marvell RAID on chip controller.
ENTER: Operation F10: Exit/Save ESC: Return
Use the Marvell RAID Utility in the Operating System:
With the Marvell RAID utility, you can set up an array or view the current array status in the operating system.
To install the utility, insert the motherboard driver disk, then go to Application Software\Install GIGABYTE
Utilities and select Marvell Raid Utility to install. Note: After the installation, you must login the utility with
the same account name and password that you use to login the operating system. If you did not set the
account password before, click Login to enter the Marvell RAID Utility directly.
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
Delete Virtual Disk
Do you want to delete this virtual disk?
Yes
Information
Vendor ID :
Device ID :
Revision ID :
BIOS Version :
Firmware Version :
PCIe Speed rate :
Configure SATA as :
No
Figure 8
- 103 -
1B4B
91A3
B1
1.0.0.1006
2.1.0.1314
2.56Gbps
IDE Mode
Appendix