Care And Cleaning; Cleaning Materials; Cleaning The Outside Of The Appliance; Cleaning The Stainless Steel Panels, Knobs And Handles - Electrolux EOD 983X Owner's Manual

Electrolux oven owner's manual
Hide thumbs Also See for EOD 983X:
Table of Contents

Advertisement

CARE AND CLEANING

BEFORE CLEANING ALWAYS ALLOW
THE COOLING FAN TO COOL THE
APPLIANCE DOWN BEFORE SWITCHING
OFF AT THE ELECTRICITY SUPPLY

CLEANING MATERIALS

Before using any cleaning materials on your
appliance, check that they are suitable and that their
use is recommended by the manufacturer.
Cleaners that contain bleach should NOT be used as
they may dull the surface finishes. Harsh abrasives
must also be avoided to prevent damaging the
stainless steel finish. See 'Cleaning the Outside of
the Appliance' below.
CLEANING THE OUTSIDE OF
THE APPLIANCE
Do not use abrasive cleaning materials eg Hob Brite,
Brillo pads or scourers on painted or printed finishes
as damage may occur. Regularly wipe over the
control panel, oven doors and handle using a soft
cloth and hot soapy water. To prevent streaking
finish with a soft cloth. Stainless steel cream
cleaners are abrasive and should be avoided as
they may damage the surface finish.
DO NOT ATTEMPT TO REMOVE ANY OF THE
CONTROL KNOBS FROM THE PANEL AS THIS
MAY CAUSE DAMAGE AND IS A SAFETY
HAZARD.
Under no circumstances should the
door assembly be detached from the
product for cleaning. Please refer to the
cleaning instructions.
CLEANING INSIDE THE MAIN OVEN
The Stayclean surfaces inside the Main Oven should
not be cleaned manually. See page 29 "Care of
Stayclean Surfaces".
The vitreous enamel oven base can be cleaned
using normal oven cleaners or aerosol oven cleaners
with care. Ensure that the manufacturers instructions
are followed and that all parts are well rinsed
afterwards.
Aerosol cleaners must not be used on Stayclean
surfaces and must not come into contact with
elements or the door seal as this may cause
damage.
CLEANING INSIDE THE TOP OVEN /
GRILL COMPARTMENT
The vitreous enamel coating in the top oven / grill
compartment can be cleaned using normal oven
cleaners or aerosol oven cleaners with care. Ensure
that the manufacturers instructions are followed and
that all parts are well rinsed afterwards.
Aerosol cleaners must not come into contact
with the door seal as this may cause damage.
REMOVING AND REPLACING WIREWORK
SIDE RUNNERS
Remove all shelves and furniture from the oven. Hold
the bottom of the wirework runners and draw the
runners towards the centre of the oven. Unhook from
the top and remove.
BRACKET
Clean the wirework runners by soaking in very hot
soapy water, mild abrasives may be used.
To replace, hook the wirework side runner into the
cavity, slide back and press into place. Ensure the
wirework runners are firmly in position before
replacing the oven shelves.
27
CAVITY CENTRE

Advertisement

Table of Contents
loading

Table of Contents