Electrolux ESF 63020 User Manual page 32

32 electrolux installation
• Remove the machine's worktop by
unscrewing the two rear retaining
screws, pull the worktop from the
back of the machine and slide out the
front slots, lifting the worktop.
• Insert the machine after adjusting the
levelling with the adjustable feet.
When inserting the machine, ensure that
the water inlet and drain hoses are not
kinked or squashed.
During all operations that involve
accessibility to internal components the
dishwasher has to be unplugged.
Be sure that once the appliance has
been installed, it is easily accessible for
the service engineer in the event that a
repair is required.
If the dishwasher is later used as a free-
standing appliance, the original worktop
must be re-mounted.
The plinth on free-standing appliances is
not adjustable.
Levelling
Good levelling is essential for correct
closure and sealing of the door. When
the appliance is correctly levelled, the
door will not catch on either side of the
cabinet. If the door does not close
correctly, loosen or tighten the adjusta-
ble feet until the machine is perfectly
level.
Water supply connections
This dishwasher may be fed with either
hot (max. 60°) or cold water. Neverthe-
less we advise you a cold water supply.
A hot water supply is not always efficient
with very soiled crockery as it shortens
the washing programmes a lot.
For making the connection itself, the
coupling nut fitted to the machine's sup-
ply hose is designed to screw onto a
3/4" gas thread spout or to a purpose
made quick-coupling tap such as the
Press-block.
The water pressure must be within the
limits given in the "Technical specifica-
tions". Your local Water Authority will ad-
vise you on the average mains pressure
in your area.
The water inlet hose must not be kinked,
crushed, or entangled when it is being
connected.
The dishwasher features fill and drain
hoses which can be turned either to the
left or the right to suit the installation by
means of the locknut.
The locknut must be correctly fitted
to avoid water leaks.
(Attention! NOT all models of dishwash-
ers have fill and drain hoses provided
with locknut. In this case, this kind of
facility is not possible). If the machine is
connected to new pipes or pipes which
have not been used for a long time, you
should run the water for a few minutes
before connecting the inlet hose.
DO NOT use connection hoses
which have previously been used for
an old appliance.