Changing The Pen Battery - Pioneer 504CMX - PDP - 50" Plasma Panel Technical Manual

3. Installation Procedures
3. Use the locking fixture on the rear panel to secure the four corners of scan device.
1 Rotate the locking fixture in the direction indicated by the arrow (rotate in the opposite direction for the left-side
fixture), to secure scan device in place.
2 Press in the locking fixture's stopper to prevent the fixture from moving.
Locking fixture
4. Attach the pen stand.
Use the furnished Allen bolt to fasten the pen stand in place to the rear side of the unit.
Rear side of unit
Pen stand
Tighten the Allen bolt using an Allen wrench (width across flats of 6 mm).
3.2.2

Changing the pen battery

Battery cover
18
Stopper
Allen bolt
AAA (LR03) alkaline battery
Notes:
¶ Insert battery correctly, aligning +/– polarities with the
indications on the battery case.
¶ To prevent damage from battery leakage, remove the battery
when not using the pen for an extended period (1 month or
more). If battery leakage occurs, wipe away any battery fluid
from inside the case and replace the battery with a new one.
¶ The provided alkaline battery should not be recharged, short-
circuited, disassembled, or disposed of in fire.
¶ When disposing of used batteries, please comply with
governmental regulations or environmental public instruction's
rules that apply in your country / area.