Satinglide™ Roll-Out Extension Rack - KitchenAid KEBK101BSS Use And Care Manual

For best results when baking layer cakes in Bake mode in non-
convection oven models, use racks 2f or 4f. Place the cakes on
the rack as shown.
For best results when baking layer cakes on 2 racks in Bake
mode in convection oven models, use racks 1ro and 5f, or 2f and
5f. Place the cakes on the rack as shown.
For best results when baking layer cakes on 2 racks in Convect
Bake mode in convection oven models, use racks 2f and 5f.
Place the cakes on the rack as shown.
BAKEWARE
To cook food evenly, hot air must be able to circulate. For
traditional cooking, allow 2" (5 cm) of space around bakeware
and oven walls. For convection cooking, allow 1" (2.5 cm) of
space around bakeware and oven walls. Use the following chart
as a guide.
NUMBER POSITION ON RACK
OF PAN(S)
1 Center of rack.
2 Side by side or slightly staggered.
3 or 4 Placement that gives best result. See the rack
position graphics in this section for pan
placement recommendations.
SatinGlide™ Roll-Out Extension Rack
The SatinGlide™ roll-out extension rack allows easy access to
position and remove food in the oven. It can be used in rack
positions 1 through 4. The SatinGlide™ roll-out extension rack
will not fit in position 5.
Open Position
A
A. SatinGlide™ Roll-out extension rack
B. Sliding shelf
Closed and Engaged Position
A
A. SatinGlide™ Roll-out extension rack
B. Sliding shelf
To Remove SatinGlide™ Roll-Out Extension Rack:
1. Slide the rack in completely so that it is closed and engaged
with the sliding shelf.
2. Using 2 hands, lift up on the front edge of the rack and push
the sliding shelf to the back wall of the oven so that the front
edge of the sliding shelf sits on the rack guides. The front
edge of the rack and the sliding shelf should be higher than
the back edge.
A
B
A. Sliding shelf
B. Rack guide
C. SatinGlide™ Roll-out extension rack
3. Pull the rack and the sliding shelf out.
To Replace SatinGlide™ Roll-out Extension Rack
1. Using 2 hands, grasp the front of the closed rack and the
sliding shelf. Place the closed rack and the sliding shelf on
the rack guide.
2. Using 2 hands, lift up on the front edge of the rack and the
sliding shelf together.
B
B
C
9