Ice Cube Thickness Adjustment; Drain Pump - Electrolux 241927600 Use & Care Manual

Electrolux ice maker use & care guide
Hide thumbs

Advertisement

Table of Contents

Ice Cube Thickness Adjustment

Interval - As Required
Ice thickness adjustments are made using the
control panel as follows:
UP
ARROW
DISPLAY
POWER
ICE
Figure 27
1.
To enter the thickness adjustment mode:
a. Touch and hold the UP ARROW button.
b. Touch and release the DOWN ARROW
button three times, then release the UP
ARROW button.
c. The display will switch to "0," to confirm
the thickness adjustment mode has
been selected.
2.
The factory setting is "0," and the total
range of adjustment is -5 to +5. Use the
UP ARROW button to raise the setting
and thicken the ice bridge, or the DOWN
ARROW button to lower the setting to thin
the ice bridge.
IMPORTANT
Ice thickness adjustment should only be made
one increment at a time. Allow ice maker
production to stabilize for 24 hours before
rechecking ice thickness.
3.
Touch and release the LIGHT button key to
exit the ice thickness adjustment mode.
4.
Remove all ice from the storage bin.
5.
Ice cubes in any given batch will vary, so
it is necessary to choose cubes from the
sample area (Figure 28) for comparison
when making adjustments. If further
adjustments are desired, repeat steps 1
through 4.
LIGHT,
DOWN
BLACKOUT MODE
& OTHER FUNCTIONS
ARROW
SAMPLE AREA
Figure 28
IMPORTANT
It is extremely important that Clear Ice models are
level. If not level, the ice mold will not fill evenly.
Operation
ICE005
15

Advertisement

Table of Contents
loading

  Related Manuals for Electrolux 241927600

Table of Contents