Panasonic AG-AC90 Operating Instructions Manual page 108

Problem
"ERROR OCCURRED.
PLEASE TURN UNIT OFF,
THEN TURN ON AGAIN."
is displayed.
Problem
Function display
(Remaining Display,
Counter Display, etc.) is
not displayed
Problem
The unit arbitrarily stops
recording.
Auto Focus function does
not work.
Color or brightness of the
image changes, or you
may see horizontal bars in
the image.
The LCD monitor flickers
indoors.
Power
≥ The unit has automatically detected an error. Restart the unit
by turning off and on.
≥ The unit will be turned off in about 1 minute if the unit is not
turned off and on.
≥ Repair is needed if it is repeatedly displayed even if it is
restarted. Detach the power connected, and consult the
dealer who you purchased this unit from. Do not attempt to
repair the unit by yourself.
Indication
≥ [CARD&BATTERY] or [OTHER DISPLAY] of the
[SW & DISP SETUP] is [OFF].
≥ Press the COUNTER button to switch the counter display.
(l 51)
Recording
≥ Use an SD card that can be used for motion picture recording.
(l 16)
≥ The recordable time may have shortened due to the
deterioration of the data writing speed or repeated recording
and deletion. Using the unit, format the SD card.
≥ Switch to Intelligent Auto Mode.
≥ If you are trying to record a scene which is hard to bring into
focus in Auto Focus Mode, use the Manual Focus Mode to
adjust the focus. (l
≥ Color or brightness of the image may change, or you may see
horizontal bars in the image when the object is recorded
under fluorescent light, mercury light or sodium light, etc., but
this is not a malfunction.
≥ Perform following operation.
j Record in the Intelligent Auto Mode
j Set the shutter speed to 1/60 in areas where the power
supply frequency is 60 Hz, or 1/100 in areas of 50 Hz.
- 108 -
Check points
Check points
(l 97)
Check points
34, 38)
(l 28)