Vt52 Emulation - Neoware c50 - Thin Client User Manual

Host Command Summary
This appendix lists the host commands that are valid in each terminal
emulation mode. Additional special commands are listed at the back.
The following conventions are used in this command list. Spaces in a command are for
clarity only and are not to be entered as part of the command. A space character that is
part of the command will be shown as SP. An asterisk (*) in a command indicates the
location of one or more parameters except otherwise indicated next to the command.
Note that IBM 3270 and IBM 5250 emulation commands are not included because of
their complexity. Refer to the manuals supplied with these terminals for the host
commands that are supported.

VT52 Emulation

CHARACTER SET SELECTION
Invoke G0 character set
Invoke G1 character set
Select G0 character set
Select Line Drawing character set
CURSOR
Direct cursor addressing (1 to 96 = SP to DEL)
Insert FF character & advance cursor
Line feed
Move cursor down one line
Move cursor down one line
Move cursor home
Move cursor one column left
Move cursor one column left
Move cursor one column right
Move cursor to left margin of current line
Move cursor to next tab stop
Move cursor up one line
Reverse line feed
Host Command Summary
C
SI
SO
ESC G
ESC F
ESC Y *line *column
FF
LF
ESC B
VT
ESC H
BS
ESC D
ESC C
CR
HT
ESC A
ESC I
C-1