Tab Settings - Neoware c50 - Thin Client User Manual

Setup Menus
displays all subsequent characters from the extended character set until an ESC SI
sequence is received to switch back to the normal character set.
The Unisys T27 emulation transmits an ESC SO sequence when it encounters
extended characters in its display buffer and an ESC SI when standard characters are
to be sent. There is no automatic shift in (ESC SI) at the end of a data transmission
block.
SPCFY key sends hex values
Factory default: Unselected
This determines whether the SPCFY key transmits in hexadecimal or ASCII (default).
SPCFY key sends page number
Factory default: Unselected
This determines whether the SPCFY key transmits the page number in addition to the
column and row information it usually sends.
VT page advance
Factory default: Unselected
If the emulation is configured for 32 lines per page, vertical tabs are set on lines 1, 9,
17 and 25 when this option is selected.
Xmit printer status
Factory default: Unselected
The setting of this option determines whether the Unisys T27 emulation informs the
host of the current printer status.

Tab Settings

This enables you to set tab stops for each environment.
Tab stops are set every eight columns by default when the Type option is set to Fixed,
as indicated by the T character above the relevant column numbers.
Individual tab stops can be toggled on or off by setting the Type option to Variable
then clicking the mouse pointer on or above the relevant column number.
To save the tab stops, click the Apply button.
To remove all the tab stops when in Variable mode, click the Clear button. Note that
switching from Fixed to Variable mode will clear all the default tabs. To restore the
default tabs, click the Default button.
The Show Ruler option enables a tab ruler to be displayed on the 25th line of the
screen.
6-68