Table of Contents
Advertisement
Error Message List
No beep Error Messages
No beep, power-on indicator turns off and LCD is
blank.
No beep, power-on indicator turns on and LCD is
blank.
No beep, power-on indicator turns on and LCD is
blank. But you can see POST on an external
CRT.
No beep, power-on indicator turns on and a
blinking cursor shown on LCD during POST.
No beep during POST but system runs correctly.
Error Beep List
Code
00h
Two long beeps, one short beep, then one long beep.
F1h
One long and one short beeps.
F2h
One long and two short beeps
D1h
Two short beeps.
Chapter 4
FRU/Action in Sequence
Power source (battery pack and power adapter). See "Power
System Check" on page 82.
Ensure every connector is connected tightly and correctly.
Reconnect the DIMM.
LED board.
System board.
Power source (battery pack and power adapter). See "Power
System Check" on page 82.
Reconnect the LCD connector
Hard disk drive
LCD inverter ID
LCD cable
LCD Inverter
LCD
System board
Reconnect the LCD connectors.
LCD inverter ID
LCD cable
LCD inverter
LCD
System board
Ensure every connector is connected tightly and correctly.
System board
Speaker
System board
Beeps
Description
Success
BIOS file size mismatch
BIOS reading error
Floppy drive not installed
88
Advertisement
Table of Contents
