Download Print this page

Bell Sonecor BE-1438VP Owner's Manual page 3

14 channel 38 sub-code family radio service transceiver value pack

Advertisement

Note: Batteries must be charged in pairs.
When charging only two batteries,
use the Front battery-charging
compartment.
3. Lock the wall plug into the out position
and plug it into an available wall jack.
The Front and/or Back LEDs will light
indicating the batteries are receiving
power.
4. Be sure to charge batteries for
approximately 7 hours to make sure
they are fully charged before use. Do
not overcharge.
Note: The charger has a built-in 15 hour
charge limit timer and will automat-
ically turn off after that time has
passed.
Warning: This charger is intended for
use with Nickel-Cadmium
and Nickel-Metal-Hydride
rechargeable batteries only.
Attempting to charge other
types of batteries may
cause personal injury and
damage to the charger.
Caution:
1. Recharge only one type (Ni-Cd or Ni-
MH) of battery at each time.
2. Do not charge longer than the
specified time. Overcharging may
cause damage to the charger and
battery.
3. Do not expose charger to rain or mois-
ture. Intended for indoor use only.
4. Do not leave plugged into the wall jack
when it is not charging.
AAA Ni-Cd BATTERIES
8 AAA Ni-Cd batteries are included with
this value pack. They will function for
approximately 3.8 hours
talk (continuous) time or
2 days standby time in
the BE-1438 radios.
NYLON BELT POUCH
The nylon belt pouches which come with
BE-1438VP value pack are designed for
more flexible use of your radio. The belt
pouch allows you to have the BE-1438
radio handy without holding it in your
hand. The secure design allows for
attachment to your belt, or lets you hang
the radio from around your neck if you use
a chain or strap (not
provided) while still being
able to access the front
panel. In the belt pouch,
the radio is more secure
and is easier to remove
and replace at your
leisure.
Care and Safety
Caution: Do not operate the BE-1438
radio at high audio volume levels when
using it with a headset. Hearing experts
advise against continuous high volume
operation. If you experience a ringing in
your ears, turn off the radio before plug-
ging in the headset.
Warning: Do not operate this radio in
hazardous environments. Explosion or
fire may result.
Do not operate this radio near unshielded
electrical blasting caps.
Under certain conditions, radios can inter-
fere with blasting operations and may
cause an explosion. Construction crews
often use remote control RF devices to
set off explosives.
IMPORTANT: Turn off your radio to pre-
vent accidental transmission when in a
"blasting area" or in areas posted: "Turn
off two way radio".
MAINTENANCE
5
The BE-1438 radio has been designed to
give years of trouble free service. To
assure longevity, please read the
following maintenance instructions.
1. To clean the radio, wipe with a soft
cloth dampened with water. Do not
use cleaners or solvents on the radio,
they can harm the body and leak
inside, causing permanent damage.
Battery contacts should be wiped with
a dry, lint free cloth.
2. If the radio gets wet, turn it off and
remove batteries, immediately. Dry
the battery compartment with a soft
cloth to minimize potential water
damage. Leave the cover off the
battery compartment overnight or
until completely dry. Do not use the
radio until completely dry.
3. In case of trouble with the BE-1438
radio, do not attempt to repair it your-
self. It is the responsibility of users
requiring service to report the need
for service to our Service
Department. They will make the
necessary arrangements for repair or
replacement.
4. If you should have questions about
the operation of the BE-1438VP,
please call our Customer Service
Department at 1-888-663-1505.
You may also contact Aastra
Telecom for technical assistance
via our Internet Web site at
www.aastra.com
Troubleshooting
SYMPTOM
SOLUTION
Does not turn on • Check that the
batteries are installed
properly.
• The batteries may be
weak. Replace old
batteries with four new
"AAA" batteries.
Reception is
• Press the
button to
weak
increase volume.
• The receiving signal
may be weak and out of
range. If this happens,
press the M button.
Range is limited • Batteries may be weak.
Replace with new
batteries if the battery
level indicator is low.
• The maximum range
will vary depending on
terrain and
environment. Open
fields provide the
maximum range, while
buildings and other
structures may limit the
range significantly.
Sound distortion • If you are transmitting,
speak in a normal tone
of voice, approximately
six inches away from
the microphone.
• If you are receiving,
lower the volume
control to a comfortable
level.
6

Advertisement

loading