Power Cord - NEC EA294WMi-BK User Manual

3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position.
4. Connect all cables to the appropriate connectors (Figure C.1). When using the USB cable, connect the B type connector
to the USB upstream port on the right back side of the monitor and the A type connector to the downstream port on the
computer (Figure C.1a). If using the cord from a USB device, plug into one of the downstream ports of the monitor.
NOTE: Incorrect cable connections may cause abnormal operation, damage display quality/components of LCD module and/
or shorten the module's life.
30° Tilt
Highest Stand
Position

Power cord

Power cord
HDMI/MHL
D-SUB2
DisplayPort DisplayPort DVI-D2 (SingleLink) DVI-D1 (DualLink)
Figure C.1
*: See page 26
5. To keep the cables neatly organized, place them into the cable management system that is built into the stand.
Place the cables in the hooks fi rmly and evenly (Figure C.2 and Figure C.3).
NOTE: Cable cover is not removable.
6. Please check that you can still rotate, raise and lower the monitor screen after you have installed the cables.
Power Cord
DisplayPort Cable*
D-SUB Cables
Figure C.2
* Cable not included.
7. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet.
NOTE: Please refer to Caution section of this manual for proper selection of AC power cord.
USB Downstream
Headphone
ControlSync IN/OUT* ControlSync IN/OUT*
Audio Input Audio Input
D-SUB1 USB Upstream USB Upstream
USB Downstream USB Downstream
DVI Cables
HDMI Cable*
Audio Cable
ControlSync Cables
USB Cables
English-7
B Type
B Type
Figure C.1a
Power Cord
DisplayPort Cable*
D-SUB Cables
Figure C.3
A Type
A Type
DVI Cables
HDMI Cable*
Audio Cable
ControlSync Cables
USB Cables