Figure 7 Slide disk enclosure onto rails
3.
Continue sliding the enclosure into the rack until the front edge is flush with the front of the rack
(1,
Figure 8 (page
7)). Tighten the enclosure thumbscrews into the rack (2), taking care not to
strip the thumbscrews.
Figure 8 Tighten disk enclosure thumbscrews
4.
Reattach the front bezel covers.
5.
At the rear of the rack, loosen the thumbscrew on the shipping retaining bracket (1,
7)) and slide the bracket forward (2,
chassis. Tighten the thumbscrew on the bracket.
Figure 9 Secure rear of enclosure
Figure 9 (page
7)) until the tab engages the slot in the
Figure 9 (page
Installing the disk enclosure
7