Installing A Sas Card - Acer AT350 F2 Series Service Manual

66

Installing a SAS card

1 Observe the pre-installation instructions on page 26.
2 Remove the side panel described on page 28.
3 If necessary, remove any cables that prevent access to the PCI slot.
4 Locate an empty expansion slot that is compatible with the
specification of the card you intend to install.
5 Unclip the restraining latch (1) and open in the direction (2) shown
below .
6 Remove the screw holding the slot in place (3).
7 Slide out the slot shield (4).
Caution: Do not discard the slot cover. If the expansion card is
removed in the future, the slot cover must be reinstalled to maintain
proper system cooling.
8 Remove the expansion card from its protective packaging, handling it
by the edges.
3 System upgrades