Something Not Working - AEG SANTO C 8 18 43 i Operating And Installation Instructions

Something Not Working

If the appliance is not functioning correctly, please carry out the following
checks before contacting your local AEG Service Force Centre.
Warning!
Repairs should only be carried out by qualified service engineers. Repairs
carried out by inexperienced persons may cause injury or serious malfunc-
tioning.
Symptom
Appliance does not work.
Appliance cools too much.
The food is too warm.
Interior lighting does not work.
Heavy build up of frost, possi-
bly also on the door seal.
The compressor does not start
immediately after changing
the temperature setting.
Water on the floor or on sto-
rage shelves.
Possible Cause
Appliance is not switched on
Mains plug is not plugged in
or is loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly
adjusted.
Door was open for an exten-
ded period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air tight (pos-
sibly after reversing the door).
This is normal, no error has
occurred.
Water drain hole is blocked.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if neces-
sary.
Electrical malfunctions are to
be corrected by an electrician.
Turn the temperature control
knob to a warmer setting.
Please look in the "Initial Start
Up" section.
Only Oopen the door as long
as necessary.
Turn the temperature control
knob to a colder setting.
Please look in the "Installation
location" section.
Please look in the "Changing
the Light Bulb" section.
Carefully warm the leaking
sections of the door seal with
a hair dryer (not hotter than
approx. 50 °C). At the same
time shape the warmed door
seal by hand until it sits cor-
rectly.
The compressor starts after a
period of time.
See the "Cleaning and Care"
section.
15