Haier HWM75-7288 User Manual page 6

NOTE:
The appliance is to be connected to the water mains using new hose-sets and
that old hose-sets should not be reused.
Confirm the water faucet
It is required that the front end shall be longer than 10mm.
The exit end face of the faucet shall be flat and smooth.If not please file it to avoid leakage.
water faucet, suitable
The exit end face of the faucet
Connection between the water inlet hose jointer and the
water faucet
1.Press the lower end of the lock lever and push
down the slider. Take off the water inlet hose
jointer from the water inlet hose component.
See to Figure 1.
2.Loosen the screw till the water faucet can be
accessed. Put the jointer of the water inlet
hose on the faucet. See to Figure 2. (If the
faucet is too large and the jointer can not be
set on the water faucet,please loosen the four
screws and take out the bushing in the jointer.
The front end of the faucet must be smooth,
otherwise it may leak water. See to Figure 3.)
3.Fasten the four screws evenly. See to Figure 4.
4.Take off the nameplate. Twist the fastening nut
as per the indication of the figure to seal up the
exit end face of the faucet. See to Figure 5.
Remark: Before installation, the threading is
4mm above the upper surface of the nut.After
installation, the threading is 2mm above the
upper surface of the nut.See to Figure 6.
6
water faucet, not suitable
Lock lever
water inlet hose
Figure 1
Screw
Sign plate
Screw knife
Figure 2
Figure 3
Figure 4
Screw nut
About 4mm before twisting
About less than 2mm after twisting
Figure 6
Figure 5
water inlet hose jointer
Slider
Bushing