Dimm Identification; Memory Configurations - HP ML150 - ProLiant - G6 User Manual

DIMM identification

IMPORTANT:
these two types causes the server to halt during BIOS initialization.
The memory subsystem may be populated with either RDIMMs or UDIMMs, but mixing the two types is not
supported. To determine DIMM characteristics, use the label attached to the DIMM and the following
illustration and table.
Item Description
1 Size
2 Rank
3 Data width
4 Memory speed
5 DIMM type
For the latest supported memory information, see the QuickSpecs on the HP website
(http://www.hp.com).

Memory configurations

To optimize server availability, the server supports the following AMP modes:
•
Advanced ECC—provides the greatest memory capacity for a given DIMM size, while providing up
to 8-bit error correction, depending on the specific DIMM type. This mode is the default option for
this server.
This server does not support mixing RDIMMs and UDIMMs. Attempting to mix
Definition
—
1R = Single-rank
2R = Dual-rank
4R = Quad-rank
x4 = 4-bit
x8 = 8-bit
10600 = 1333-MHz
8500 = 1067-MHz
R = RDIMM (registered)
E = UDIMM (unbuffered with ECC)
Hardware options installation 25