Connecting The Switch; Switch To End Node - D-Link DES-3205 Hardware Installation Manual

C
ONNECTING THE

Switch to End Node

Switch to Hub or Switch
NOTE: All 10/100/1000Mbps NWay Ethernet ports can support both MDI-II and MDI-X
connections.
S E
WITCH TO ND
End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ 45 Ethernet/Fast Ethernet Network Interface Card
(NIC) and most routers. An end node can be connected to the Switch via a twisted-pair Category 3, 4, or 5
UTP/STP cable. The end node should be connected to any of the ports of the Switch.
The Link/Act LEDs for each UTP port will light green or amber when the link is valid. A blinking LED indicates packet
activity on that port.
Connecting the Switch - Switch to End Node
D-Link™ Hardware Installation Guide – DES-3200 Series Switch
S
WITCH
N
ODE
Figure 3- 1. DES-3200-28 connected to an end node
Figure 3- 2. DES-3200-28F connected to an end node
4
Page | 22