POWER SUPPLY VOLTAGE AND FREQUENCY
TOTAL POWER ABSORBED
AVERAGE DAILY UNITS
(*)This figure is based on standard test results in accordance with European Standard EN153. Actual con-
sumption will depend on how the appliance is used and where it is located.
This appliance should only be installed at a location
where the ambient temperature corresponds to the cli-
mate classification indicated on the rating plate, which
is located on the inside left of the appliance.
The following table shows which ambient temperature
is correct for each climate classification.
+10°C to +32°C
+18°C to +38°C
The appliance should be located in a dry atmosphere,
out of direct sunlight and away from continuous heat
and extreme temperature, e.g. not next to a boiler or
radiator, or in a very cold room e.g. an outhouse. If
these temperatures are exceeded i.e. warmer or cold-
er, then the appliance may not operate correctly.
For building-in and door reversal instructions please
refer to the relevant instructions on the following
220-240 V / 50 Hz