Quick Reference; Attaching The Stand - Sharp Aquos LC-60LE845U Operation Manual

QUICK REFERENCE

Attaching the Stand

• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.
CAUTION
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
■ LC-70LE845U
1 Confirm that there are 12 screws (6 long screws,
4 middle screws and 2 short screws) supplied with
the stand unit.
2
1 Set the post for the stand unit onto the
polystyrene foam.
2 Attach the base to the post.
3 Insert and tighten the 6 screws into the 6 holes
on the bottom of the base.
• Hold the stand unit securely with one hand, and then
tighten the screws.
2
1
1
Insert the stand into the openings on the rear of the TV.
3
• Make sure that the stand is fi rmly inserted into the TV.
Improper installation may result in tilting of the TV set.
Soft cushion
4 Insert and tighten the 4 screws into the 4 holes on
the rear of the stand unit.
1 Insert the stand cover.
5
2 Insert the 2 screws to secure the stand cover.
1
1
• In the installation procedure, be careful not to catch your fi ngers between the TV set and the
fl oor.
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
• After attaching the stand to the TV, do not hold the stand when you put up, set up,
move or lay down the TV. (For LC-70LE845U)
3
Long screws
FRONT
Middle screws
Short screws
2
■ LC-60LE845U
1 Confirm that there are 10 screws (4 long screws, 4 middle
screws and 2 short screws) supplied with the stand unit.
2
1 Attach the supporting post for the stand unit
onto the base.
2 Insert and tighten the 4 screws into the 4 holes
on the top of the supporting post.
• The supporting post attaches to the base at an off-
centered location on the base. Be sure to attach the
supporting post in the direction indicated below and
attach the stand to the TV with the wider side of the
base facing forward.
2
Long screws
1
3 Insert the stand into the openings on the rear of the TV.
• Make sure that the stand is fi rmly inserted into the TV.
Improper installation may result in tilting of the TV set.
Soft cushion
4 Insert and tighten the 4 screws into the 4 holes on
the rear of the stand unit.
1 Insert the stand cover.
5
2 Insert the 2 screws to secure the stand cover.
1
Forward
Middle screws
Short screws
2
9