Table of Contents
Advertisement
This procedure gives you instructions for installing and using the TFT5017/FP5017 LCD monitor display.
1.
Position the display on the desired operation and plug the power cord into a convenient AC outlet.
Three-wire power cord must be shielded and is provided as a safety precaution as it connects the chassis
and cabinet to the electrical conduct ground. If the AC outlet in your location does not have provisions
for the grounded type plug, the installer should attach the proper adapter to ensure a safe ground
potential.
2.
Connect the 15-pin color display shielded signal cable to your signal system device and lock both
screws on the connector to ensure firm grounding. The connector information is as follow:
PIN NO.
1.
2.
3.
4.
5.
6.
7.
8.
3.
Apply power to the display by turning the power switch to the "ON" position and allow about thirty
seconds for Panel warm-up. The Power-On indicator lights when the display is on.
4.
With proper signals feed to the display, a pattern or data should appear on the screen, adjust the
brightness and contrast to the most pleasing display, or press auto-key to get the best picture-quality.
5.
This monitor has power saving function following the VESA DPMS. Be sure to connect the signal cable
to the PC.
6.
If your TFT5017/FP5017 LCD monitor requires service, it must be returned with the power cord.
3. OPERATING INSTRUCTIONS
1
6
11
15 - Pin Color Display Signal Cable
DESCRIPTION
RED
GREEN
BLUE
NC
GND
GND-R
GND-G
GND-B
6
5
10
15
PIN NO.
9.
5V power from VGA-card
10.
GND
11.
NC
12.
SDA
13.
HORIZ. SYNC
14.
VERT. SYNC
15.
SCL
DESCRIPTION
Advertisement
Table of Contents
