Table of Contents
Advertisement
b. Click Dell Printers.
c. Click Dell Photo P703w AIO Printer® WiFi Config Utility.
Configuring Wireless using Wi-Fi Protected Setup (WPS) – Advanced Users Only
Follow these instructions carefully to configure your printer's wireless settings using Wi-Fi Protected Setup.
WPS is available only if you are using a WPS-enabled router. If you are not sure if your router is WPS enabled, check the router for the WPS logo.
NOTE:
Wireless configuration using WPS is only recommended for advanced users.
Before configuring your printer using WPS, you must know the router's IP address. If you are not sure of the router's IP address, you can configure wireless
using a temporary USB cable. For more information, see
NOTE:
Ensure that your computer is connected to the wireless network.
At your computer:
1. Using an Internet browser type your router's IP address and press the Enter key. Your router's web page opens.
NOTE:
You may be prompted to enter your username and password. If you are not sure of the username and password, contact your router
manufacturer's helpline or your Internet service provider.
2. On your router's web page, navigate to the WPS section.
NOTE:
The location of this page may change depending on the manufacturer of the router you are using.
At your printer's Operator Panel:
3. Press the Menu button
.
4. Press the down Arrow button
5. Press the down Arrow button
NOTE:
The blue Wi-Fi indicator LED starts flashing blue.
Configuring Wireless Using a Temporary USB
to scroll to Network, then press the Select button
to scroll to WiFi Radio and ensure that it is turned On.
Cable.
.
Advertisement
Table of Contents
