Water outlet hose connection
The end of the drain hose can be connected in the following ways:
1. To the sink outlet spigot, securing it to the underside of the work surface. This
will prevent waste water from the sink running into the machine.
2. To a stand pipe provided with vent-hole, minimum internal diameter 4 cm.
The waste connection must be at a height of
between 40 cm (minimum) and 85 cm (maxi-
mum) from the bottom of the dishwasher.
The drain hose can face either to the right or
left of the dishwasher.
Ensure the hose is not bent or squashed as this
could prevent or slow down the discharge of
The sink plug must not be in place when the
machine is draining as this could cause the
water to syphon back into the machine.
If you use a drain hose extension it must be no longer than 2 metres and its internal
diameter must be no smaller than the diameter of the hose provided.
Likewise the internal diameter of the couplings used for connections to the waste
outlet must be no smaller than the diameter of the hose provided.
When connecting the drain hose to an under sink trap spigot, the entire plastic
membrane (A) must be removed. Failure to remove all the membrane will result
in food particles building up over time eventually blocking the dishwasher drain
Our appliances are supplied with a security device to
protect against the return of dirty water back into the
machine. If the spigot of your sink has a "no return valve"
incorporated this can prevent the correct draining of
your dishwasher. We therefore advise you to remove it.