Table of Contents
Advertisement
Fitting the hob to the worktop
Before fitting the hob into
the cut out, an adhesive seal
must be fitted to the
underside outside edge of the
hob. It is essential that no
gaps are left in this seal in
order to prevent spillage near
the hob seeping into the
cabinet below.
1) Remove the pan supports,
the burners caps and
crowns and turn the hob
upside down, taking care
the ignition candles are
not damaged in this
operation.
2) Place the sealing gasket
all around the glass top
edge as shown in the
diagram.
3) Fit the hob in the cut out
and push it down until
the glass top and the
working top make
contact, as shown in the
diagram.
FO 2108
FO 2107
Building in
A
A) Sealing gasket
19
Advertisement
Table of Contents
