Error Message - Dell 1135N Service Manual

4.1.10 Error Message

Messages appear on the control panel display to indicate the machine's status or errors. Refer to the tables
below to understand the messages' and their meaning, and correct the problem, as is necessary.
Checking display messages
• If a message is not in the table, reboot the power and try the printing job again.
• Some messages may not appear in the display depending on the options or models.
• [error number] indicates the error number.
• [tray type] indicates the tray number.
• [media type] indicates the media type.
• [media size] indicates the media size.
• [color] indicates the color of toner or imaging unit.
Message
[COMM. Error]
[Incompatible]
[Line Error]
[No Answer]
[Stop Pressed]
ADF COVER
OPEN ERROR
BOOTP problem
Auto IP Run
BOOTP problem
Reconfigure DHCP
DHCP problem
Reconfigure BOOTP
Service Manual
Alignment and Troubleshooting
Meaning
The machine has a communication
problem.
The machine has received a fax which
is registered as a junk fax.
Your machine cannot connect with the
receiving fax machine or has lost
contact because of a problem with the
phone line.
The receiving fax machine has not
answered after several redial ttempts.
Stop/Clear has been pressed during
an operation.
The ADF cover is opened.
The IP address assignment is failed.
This happens, when Auto IP for
BOOTP is set in SyncThru Web
Service.
The IP address assignment is failed.
This happens, when Auto IP for
BOOTP is not set in SyncThru Web
Service.
The IP address assignment is failed.
This happens, when Auto IP for DHCP
is set in SyncThru Web Service.
4-24
Suggested solutions
Ask the sender to try again.
The received fax data will be deleted.
Reconfirm junk fax setup.
Try again. If the problem persists, wait
an hour or so for the line to clear and
try again. Or, turn the ECM mode on.
Try again. Make sure that the receiving
machine is operational and has paper.
Try again.
Close the ADF cover.
Change the IP address assignment
method to DHCP or Static. If you do
not change this option, the BOOTP
server continually asks to assign the
IP Address.
Change the IP address assignment
method to DHCP or Static. If you do
not change this option, the BOOTP
server continually asks to assign
the IP Address.
Change the IP address assignment
method to BOOTP or Static. If you
do not change this option, the DHCP
server continually asks to assign
the IP Address.