Table of Contents
Advertisement
Installing the Processor Airflow Shroud
1. Attach both fan power cables to the connectors on the system board.
2. Align the anchor tabs with the securing slots.
3. Gently press the shroud until the anchor tabs snap securely into place.
4. Close the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn them on.
Processor
Removing the Processor
NOTICE:
Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly could
damage your system board.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1. Follow the procedures in
"Before You
2. Disconnect the cooling fan power cable from the REAR FAN1 connector (see
3. Disconnect the power cable from the 12V PWR connector (see
4. Lift up the airflow shroud.
Begin."
"System Board
"System Board
Components") on the system board.
Components") on the system board.
Advertisement
Table of Contents
