Yamaha MCX-A10 - MusicCAST Network Audio Player Manual page 3

Caution: read this before operating this unit
• To assure the finest performance, please read this manual
carefully. Keep it in a safe place for future reference.
• Install this unit in a well ventilated, cool, dry, clean place –
away from direct sunlight, heat sources, vibration, dust,
moisture, and/or cold. Avoid ventilation space of at least 30 cm
on the top, 20 cm on the left and right.
• Locate this unit away from other electrical appliances, motors,
or transformers to avoid humming sounds.
• Do not expose this unit to sudden temperature changes from
cold to hot, and do not locate this unit in a environment with
high humidity (i.e. a room with a humidifier) to prevent
condensation inside this unit, which may cause an electrical
shock, fire, damage to this unit, and/or personal injury.
• Avoid installing this unit where foreign objects may fall onto
this unit and/or this unit may be exposed to liquid dripping or
splashing. On the top of this unit, do NOT place:
• Other components, as they may cause damage and/or
discoloration on the surface of this unit.
• Burning objects (i.e. candles), as they may cause fire,
damage to this unit, and/or personal injury.
• Containers with liquid in them, as they may fall and liquid
may cause electrical shock to the user and/or damage to
this unit.
• Do not cover the rear panel of this unit with a newspaper,
tablecloth, curtain, etc. in order not to obstruct heat radiation.
If the temperature inside this unit rises, it may cause fire,
damage to this unit, and/or personal injury.
• Do not plug this unit in to a wall outlet until all connections
are complete.
• Do not operate this unit upside-down. It may overheat,
possibly causing damage.
• Do not use force on switches, knobs and/or cords.
• When disconnecting the power cord from the wall outlet, grasp
the plug; do not pull the cord.
• Do not clean this unit with chemical solvents; this might
damage the finish. Use a clean, dry cloth.
• Only the voltage specified on this unit must be used. Using this
unit with a higher voltage than specified is dangerous and may
cause fire, damage to this unit, and/or personal injury.
YAMAHA will not be held responsible for any damage
resulting from use of this unit with a voltage other than
specified.
• To prevent damage by lightning, disconnect the power cord
from the wall outlet during an electrical storm.
• Do not attempt to modify or fix this unit. Contact qualified
YAMAHA service personnel when any service is needed. The
cabinet should never be opened for any reasons.
• When not planning to use this unit for long periods of time (i.e.
vacation), disconnect the AC power plug from the wall outlet.
• Be sure to read the "TROUBLESHOOTING" section on
common operating errors before concluding that this unit is
faulty.
• Before moving this unit, press STANDBY/ON to place the
unit in standby mode, and disconnect the AC power plug from
the wall outlet.
• Be sure to use the AC adaptor (LSE0107A1240) supplied with
this unit. Otherwise, you might cause a fire or damage to this
unit.
• This unit is designed for home use only. Never use this unit in
a car, etc., otherwise it may cause a malfunction of this unit.
This unit is not disconnected from the AC power source as
long as it is connected to the wall outlet, even if this unit
itself is turned off. This state is called the standby mode. In
this state, this unit is designed to consume a very small
quantity of power.
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS UNIT TO RAIN OR
MOISTURE.
IMPORTANT!
Please record the serial number of this unit in the space
below.
Model:
Serial No.:
The serial number is located on the rear of the unit.
Retain this Owner's Manual in a safe place for future
reference.
SPECIAL INSTRUCTIONS FOR U.K. MODEL
IMPORTANT
The wires in this mains lead are colored in accordance with
the following code:
GREEN-and-YELLOW:Earth
BLUE:Neutral
BROWN:Live
As the colors of the wires in the mains lead of this apparatus
may not correspond with the colored markings identifying
the terminals in your plug proceed as follows: The wire
which is colored GREEN-and-YELLOW must be connected
to the terminal in the plug which is marked by the letter E or
by the safety earth symbol
and -YELLOW. The wire which is colored BLUE must be
connected to the terminal which is marked with the letter N
or colored BLACK. The wire which is colored BROWN
must be connected to the terminal which is marked with the
letter L or colored RED.
For U.K. customers
If the socket outlets in the home are not suitable for the plug
supplied with this appliance, it should be cut off and an
appropriate 3 pin plug fitted. For details, refer to the instructions
described above.
Note: The plug severed from the mains lead must be destroyed,
as a plug with a bared flexible cord is hazardous if engaged in a
live socket outlet.
For Canadian Customers
To prevent electric shock, match wide blade of plug to wide
slot and fully insert.
This Class B digital apparatus complies with Canadian
ICES–003.
4
or colored GREEN or GREEN-