What To Look For - Xerox DocuPrint NC60 Administrator's Manual

What To Look For

There are basically three things to look for in examining
the test print.
1. The Color Density and the Black Density are a matter
of taste. The 30% halftones can be used to judge the
current level and decide on a preference.
2. The Color Density and Black Density should be at
approximately the same level. This is important in
order to make the Color Balance adjustment.
3. The correct Color Balance is determined by
comparing the circle in the center of the Color
Balance object marked "CURRENT" with the gray
background. The background is produced using black
only and the circles are produced using a combination
of cyan, magenta, and yellow. The adjustment
objective is for the "CURRENT" circle to be the closest
gray of any of the circles when compared to the
background.
Chapter 4: Maintaining the Printer
Adjusting Density and Color Balance
4-11