Electrical Connection - AEG FAVORIT 40740 User Instructions

Installation and Connection Instructions

Electrical Connection

Any electrical work required to install this appliance should be car-
ried out by a qualified electrician or competent person.
WARNING - This appliance must be earthed.
1
The manufacturer declines any responsibility should these safety
measures not be observed.
Before switching on make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate.
To isolate the dishwasher from the mains, remove the mains plug.
Important: The plug must still be accessible after the appliance has
been installed.
Changing a fuse
The appliance is supplied with a 13amp plug fitted. In the event of hav-
ing to change the fuse in the plug supplied, a 13amp ASTA approved
(BS 1363A) fuse must be used.
Should the plug need to be
replaced for any reason, proceed as
described below.
The wires on the mains lead are
coloured in accordance with the
following code.
Green and Yellow : Earth
Blue
Brown
• The wire coloured green and yellow must be connected to the termi-
nal marked with the letter "E" or by the earth symbol
green and yellow.
• The wire coloured blue must be connected to the terminal "N" or col-
oured black.
• The wire coloured brown must be connected to the terminal marked
"L" or coloured red.
• Upon completion there must be no cut, or stray strands of wire
present and the cord clamp must be secure over the outer sheath.
WARNING! A cut off plug inserted into a 13 amp socket is a seri-
1
ous safety (shock) hazard. Ensure that, if it is necessary to cut off
the plug, it is disposed of safely and not retained.
40
: Neutral
: Live
Green
& Yellow
Blue
Cord Clamp
Brown
or coloured