Installation; Overview; Installing Adapter In Pci Slot; General Steps - HP LC2000r - NetServer - 128 MB RAM Manual

Fibre channel host bus adapter

Hide thumbs Also See for LC2000r - NetServer - 128 MB RAM:

Table of Contents

Installation

Before installing the Adapter in your server, make sure that the system is

powered down and that you follow ESD procedures to reduce the risk of

damage to the Adapter or the server electronics. See Appendix A regarding

ESD information.

Install the Adapter in any standard PCI slot. The following generalized

installation steps pertain to most PCI installations. Most system chassis are

either vertical or horizontal orientated, therefore, you should install your card

depending on the orientation of your system. Consult your server or workstation

manual for PCI card installation.

1. Back up your work and turn off power to your system.

2. Remove the chassis cover.

3. Locate an empty PCI expansion slot in your system.

4. Remove the expansion slot cover. (Save the slot cover screw.)

5. Insert the HP Fibre Channel Adapter into the slot until it is firmly seated.

Refer to Figure 2-1. on page 6.

6. Replace the slot cover screw.

Table of Contents