Canada Rfi Statement; European Union Rfi Statement; Laser Safety - HP L1000 - 9000 - 0 MB RAM Safety And Regulatory Information Manual

FCC Statement (USA Only)
The United States Federal Communications Commission has specified that the following notice be
brought to the attention of users of this product:
NOTE This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Hewlett-Packard's system verification tests were conducted with HP-supported peripheral devices and
HP shielded cables, such as those you receive with your computer. Changes or modifications not
expressly approved by Hewlett-Packard could void the user's authority to operate the equipment. Cables
used with this device must be properly shielded to comply with the requirements of the FCC.

Canada RFI Statement

This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.

European Union RFI Statement

This is a Class A product. In a domestic environment, this product may cause radio interference in which
case the user may be required to take adequate measures.
Acoustics (Germany)
Acoustic noise level per ISO 9296 (25° C):
LpA <60dB (operators position)
m
Australian C-Tick Label

Laser Safety

This product contains a laser internal to the Optical Link Module (OLM) for connection to the Fibre
communications port.
In the USA, the OLM is certified as a Class 1 laser product conforming to the requirements contained in
the Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter J. The
certification is indicated by a label on the plastic OLM housing.
Outside the USA, the OLM is certified as a Class 1 laser product conforming to the requirements
contained in IEC 825-1:1993 and EN 60825-1:1994, including Amendment 11:1996.
14 English