Configuring Your Network Connection; Controlling The Network Security Features - HP Kayak XW U3-W3 Manual

HP Kayak XW U3 & W3 PC Workstation — Setting Up and Using Your HP PC Workstation

Configuring Your Network Connection

Configuring Your Network Connection
Use the information in this section if your PC Workstation comes with
an HP-supplied integrated network solution.
You must use the PC Workstation's Setup program to change the
integrated Ethernet interface settings. The following table summarizes
which network options you can set using the Setup program.
Network Setup Items
Enable the integrated network interface.
Enable your PC Workstation to be started (booted
and logged on) from the network.
Enable remote power-on of your PC Workstation.
From "Suspend Wakeup" mode, enable your PC
Workstation to return to full power when a
command is received by the integrated network
interface.
Determine boot device priority.
1. For full information on setting up your network, refer to the online Network Administrator's
Guide preloaded onto your PC Workstation.
2. Disabling the LAN card will only disable certain features of the LAN card, such as remote
power-on or remote wakeup, not the card itself.

Controlling the Network Security Features

The Security Features allow you to enable starting from the network if
you want the PC Workstation to start from a LAN server. To enable
starting from the network:
1 With the Setup program running, use the
the Security menu.
16 English
1
Where to find in Setup
2
In the Advanced menu, go to the Integrated
Network Interface submenu.
In the Security menu, go to the Boot Devices
Security submenu (described below).
In the Power menu, enable the Integrated
Network item.
In the Power menu, enable the Integrated
Network item.
In the Boot menu, select the Boot Device
Priority list item (described on the next page).
or key to select