Cleaning The Cooker; Safety Warnings About Cleaning; Cleaning The Enamel; Cleaning The Control Panel - Electrolux GAS ELEVATED COOKERS Manual

Gas elevated cookers
Table of Contents

Advertisement

Cleaning the Cooker

Safety Warnings about cleaning

ALWAYS make sure that the cooker is turned off before cleaning.
ALWAYS clean cooker immediately after use.
DO NOT use steam cleaners. These may cause moisture build-up.
DO NOT use caustic based cleaners. These will damage aluminium parts.

Cleaning the enamel:

Cleaning the control panel: •

Cleaning the cooktop

1. Remove the trivets (see diagram opposite) by lifting
them from hob.
2. Remove the burner caps and crowns (see diagram
opposite).
3. Wash hob with warm soapy water.
4. If crowns and caps are heavily soiled use a non-abrasive
cleaning compound.
DO NOT use abrasive or caustic based cleaners.
DO NOT wash in a dishwasher.
NOTE:
DO NOT drop trivet onto hob. This may damage
the enamel surface.
Refitting the burner crowns and caps
The burner crown must be fitted correctly into
the burner cup or damage will occur during
operation.
To do this ensure that the 2 ribs on either
side of the spark plug hole are positioned
into the 2 slots on the burner cup.
(see diagram opposite)
The burner cap is simply positioned
over the top of the burner crown.
14
Keep enamel clean by wiping it with a soft cloth dipped in warm soapy
water.
Rub difficult stains with a nylon scourer or creamed cleanser.
DO NOT use abrasive cleaners, powder cleaners, steel wool or wax
polishes.
If you use an oven cleaner, follow the instructions on the product carefully.
Make sure control knobs are in OFF position.
Remove knobs from control panel by pulling towards you.
DO NOT use too much water when cleaning control panel.
Flame port
Spark Plug Hole
Burner Crown
Burner cup

Advertisement

Table of Contents
loading

This manual is also suitable for:

Chef series

Table of Contents