Download Print this page

Electrolux EKC607601 User Manual page 26

Electrolux cooktop user manual
Hide thumbs

Advertisement

26 electrolux
Minimum distances
Dimension
A
B
LEVELLING
Use small feet on the bottom of appliance
to set same level of cooker top surface with
other surfaces
THE ANTI-TILT PROTECTION
Caution! You must install the anti-tilt
protection (A+B). If you do not install it
the appliance can tilt.
Before you install anti-tilt protection,
adjust the appliance to the correct
height.
The anti-tilt protection has two parts (A+B).
You can find the anti-tilt protection (B) on
right or left side of the rear wall of the appli-
ance (See fig. 1). You must install the anti-
tilt protection (A) on the wall. The distance
of the hole of the anti-tilt protection (A) from
the floor is about 816 mm. Make sure you
B
A
A
mm
2
685
install the anti-tilt protection (A) at the cor-
rect height. Screw it into the solid material
or use applicable reinforcement.
Check that the anti-tilt protection projects
minimum 20 mm into the hole in the back
of the appliance (B) when you push the ap-
pliance (See fig. 2). If the space between
the bench cupboards is greater than the
width of the appliance, you must adjust the
side measurement to centre the appliance.
Make sure that the surface behind the ap-
pliance is smooth.
1
2
ELECTRICAL INSTALLATION
Warning! Only a qualified and
competent person must do the
electrical installation.
The manufacturer is not responsible if
you do not follow safety precautions
from the chapter "Safety information".
This appliance is supplied without a main
plug or a main cable.
COVERING TERMINAL BOARD
The recommended cross-section area is six
square millimetres (6 mm²).
When you refit the mains terminal cover,
make sure that the lower tabs are located
inside the bottom edge of the aperture, be-
fore you fix the two screws into the top
edge of the mains terminal cover.
60 mm
50 mm
A
B

Advertisement

loading

  Also See for Electrolux EKC607601

  Related Manuals for Electrolux EKC607601

This manual is also suitable for:

Ekc607601xEkc607601w