Electrical Connection - Electrolux EHP 600 K Operating And Assembly Instructions Manual

Electrical connections
Before connecting the appliance, check that the
voltage quoted on the rating plate - that is, the no-
minal voltage of the appliance - corresponds to
the available mains voltage. The rating plate can
be found on the base of the ceramic glass hob.
.
The mains connection must be carried out by an
expert electrician. The VDE-regulations and the
valid regulations by the electricity supply boards
have to be compiled with.
.
Prior to connection it should be checked whether
the voltage stated on the rating plate -- i.e. the
nominal voltage of the appliance -- is identical with
the mains voltage. The rating plate is located on
the base of the hob.
.
The heating element voltage is 230 V ~. The
appliance will also perfectly perform with the lo-
wer mains voltage of 220 V ~.
.
The mains connection must be carried out in a
way that an all--pole insulating device is existing
with a contact opening of at least 3 mm, e.g. LS--
automatism, earth--leakage circuit--breaker or
fuse.
.
A wire of type H05VV-F or of higher rating is to be
used as supply cable.
.
The mains terminal is located in the bottom of the
appliance under a plastic cover. It can be opened
using a screwdriver (see picture).
.
Subject to the existing mains voltage, the ap-
pliance has to be connected as shown opposite.
The links of the terminal block must be changed
accordingly, if appropriate.
.
The earth conductor is to be connected to termi-
nal . The earth conductor must be longer than
live leads.
.
The cable connections have to be connected
as shown and the terminal screws be firmly
tightened.
.
Afterwards the supply cable has to be secured by
the cable clamp and the cover must be fitted by
firmly pressing down until it engages.
Prior to first use remove any existing labels and
protective film from the ceramic glass plate or the
frame of the hob.
After connecting the electrical supply, all cooking
zones should be briefly switched on one after the
other at their maximum power, in order to test
whether they are operational.
Mains terminal
in the base of the hob
strain relief device
Connecting possibilities
1 2
L1
1 2
L1
1 2
L1 L2 L3
1 2
(L3)
L1
1 2
L1
Read the installation instructions before con-
necting the mains cable. Ensuring that the
links are fitted correctly to the terminal block
14
changing brid-
ges of the ter-
minal
3 4 5
UK only
230 V
1 L + N
N
3 4 5
400 V
2 N
2 L + N
L2 N
3 4 5
400 V
3 N
3 L + N
N
3 4 5 230 V
2 L
L2
3 4 5
230 V
3 L
L2 L3
~
~
~
2
~
3
~