Electrolux EHD 6005 P Installation And Operating Instructions Manual page 24

• This appliance's mains cable is fixed directly to the board. If the mains ca-
ble is damaged, it must only be replaced by a qualified ecletrician or our
Customer Care Department.
A device must be provided in the electrical installation which allows the ap-
pliance to be disconnected from the mains at all poles with a contact open-
ing width of at least 3 mm
Suitable isolation devices include line protecting cut-outs, fuses (screw type
fuses are to be removed from the holder), earth leakage trips and contac-
tors.
Sticking on the seal
• Clean the worktop in the area of the cut-out section.
• Stick the one-sided self-adhesive sealing tape supplied all the way round
the lower edge of the cooking surface along the outer edge of the glass
ceramic panel. Do not stretch it. The cut ends should lie in the middle of
one side. When you have cut it to length (add a few mm), press the two
ends flush up against one another.
24