Electrolux E30EC65ESS Specifications page 4

Drop-In Cooktop/Downdraft Vent
Countertop Preparation
Countertop Preparation for 30" & 36" Drop-In Cooktop /Downdraft Vent Installation
Top
23 1 / "
4
min.
C
25"
E30DD75ESS / 30" Cooktop Cutout Dimensions
30" Cooktops
E30EC65ESS
E30EC70FSS
E30GC64ESS
E30GC70FSS
E30IC75FSS
Countertop
3 /
backsplash
Studwall
3"
1 15 / "
16
Stiffener
Vertical noncombustible surface - rear wall
Drop-In Cooktop / Downdraft Vent
Countertop Preparation Specifications
For detailed Drop-In Cooktop installation, refer to model-specific product
•
page and installation guide on web. Plan installation so that all required
minimum clearances between cooktop, overhead cabinets and adjacent
vertical walls are provided.
Position cooktop/vent cutout so all required minimum clearances are met.
•
Minimum flat countertop area must meet or exceed combined overall
•
width and depth as shown. Standard 25" countertop depth may NOT be
adequate for some cooktop / vent installations, especially with backsplash.
Separate circuits required for cooktop and vent. (Refer to product-specific
•
electrical specifications.)
Always consult local and /or national electric and gas codes. Check local
•
building codes for installation requirements, as they may vary per locale.
Downdraft Vent Specifications
For detailed Downdraft Vent installations, refer to model-specific
•
product page and installation guide on web.
Voltage Rating – 120V / 60 Hz / 15 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.0 kW
•
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
Electrolux Major Appliances, N.A.
250 Bobby Jones Expressway
USA
• •
CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4
• •
DIC_DDV_PREP 01/09
Vertical noncombustible surface - rear wall
B
Flush with
back side of
cabinet front
A
A B C D
30" 27 3 / " 20 3 / " 23 3 / " 24
4 8 16
30" 27 3 / " 20 1 / " 23 1 / " 24
4 4 16
27 1 / " 27 3 / " 19 7 / " 22 11 / " 23
2 4 8 16
28 1 / " 27 3 / " 19 3 / " 22 9 / " 23
2 4 4 16
29 3 / " 27 3 / " 20 1 / " 23 5 / " 24
4 4 2 16
25" (standard countertop) *
" max. backsplash thickness
4
1 / " min. flat ledge
4
2 13 / "
Countertop
16
Downdraft
2 1 / " raised lip
chimney top
8
Cooktop
9 / "
32
Vent unit
Back side of
2 13 / "
cabinet front
16
23 1 / " min.
4
Augusta, GA 30907 1-877 -4electrolux (1-877 -435-3287)
•
1-800-265-8352
•
Backsplash
3 / " max.
4
D*
1 / " min.
4
flat ledge
E**
* Overall flat ledge behind
backside of cabinet front
** Minimum flat surface required
to fit top surface of cooktop
and downdraft vent cap
E36DD75ESS /36" Cooktop Cutout Dimensions
E 36" Cooktops
3 / " E36EC65ESS
16
1 / " E36EC70FSS
16
11 / " E36GC65ESS
16
9 / " E36GC70FSS
16
5 / " E36IC75FSS
16
Cooktop Installation Note:
To ensure proper installation, refer to model-specific installation
guide on web for cooktop dimensions, cutout dimensions and
cabinet requirements. Due to varying cooktop depths, tight fit
is possible between cooktop and vent.
Countertop Preparation Note:
Be aware of areas of potential interference called out in
illustration. Countertop with raised lip and/or backsplash may
not allow enough flat area for proper installation, 2-13/16"
of flat countertop required behind cooktop. No gap required
between back of cooktop and front of downdraft trim piece.
*Standard 25" countertop depth may NOT be adequate for
some cooktop/vent installations, especially with backsplash.
Amps @ 120 Volts = 8.0 Amps
•
Vent unit outside of building only.
•
Vent must be installed in vertical orientation only.
•
1,600 CFM remote exhaust blower (PN # 5304444802)
•
included with vent – shipped in separate box.
Do not use flexible duct. Round duct instead of rectangular duct
•
recommended, especially when elbows are required.
When multiple elbows are necessary, ensure a minimum of 24" of
•
straight duct between any two elbows.
Thermal breaks such as short section of nonmetallic duct, should
•
be used in areas of extreme cold.
For most efficient airflow exhaust, use a straight run or as few elbows
•
as possible.
Cold weather installations should have additional backdraft damper
•
installed.
Installing a Downdraft Vent in combination with any gas cooking
•
surface will affect optimum burner efficiency.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxicon.com for detailed instructions.
electroluxicon.com
•
electroluxicon.ca
•
© 2009 Electrolux Home Products, Inc.
For detailed cooktop and
downdraft vent installation
2 9 / " specifications, refer to
16
model-specific product
page and installation
guide on web
A B C D E
36" 33 3 / " 20 3 / " 23 3 / " 24 3
4 8 16
36" 33 3 / " 20 1 / " 23 5 / " 24 5
4 2 16
33 3 / " 33 3 / " 19 7 / " 22 11 / " 23 11
4 4 8 16
34 1 / " 33 3 / " 19 3 / " 22 9 / " 23 9
2 4 4 16
36" 33 3 / " 20 1 / " 23 5 / " 24 5
4 2 16
High standards of quality at Electrolux Home Products, Inc. mean we are
constantly working to improve our products. We reserve the right to change
specifications or discontinue models without notice.
/ "
16
/ "
16
/ "
16
/ "
16
/ "
16
Printed in the U.S.A.