Setting The Bobbin - Brother PC-3000 Operation Manual

Setting the bobbin

1
1
1
1. Slide open the bobbin cover.
1 Bobbin cover
2 Bobbin cover release button
2
2. Insert the bobbin into the shuttle with the thread direction as
shown in the diagram.
3. Guide the thread end through the slit, then pull the thread to-
ward you to cut off any excess thread.
1 Built-in thread cutter
4. Close the bobbin cover by placing the left end in place and
pressing down lightly on the right end so that it snaps into
place.
2
* You can begin sewing immediately without drawing up the bob-
bin thread.
15