Download  Print this page

Diode Circuit Inspection - KAWASAKI ZX400-H2 Quick Reference Manual

Quick reference guide (part 3).
Hide thumbs

Advertisement

Table of Contents
15-36 ELECTRICAL SYSTEM
Starter Circuit
• Remove the junction box (see Fuse Removal)
.
• Check
conductivity
of the
following
numbered terminal
by connecting the hand tester (special tool) and one
12 V battery to the junction box as
shown.
*If the relay does not work as specified, replace the
junction box.
Relay Circuit Inspection
(with the battery disconnected)
Meter
Connection
Meter Reading
11
-
13
00
12
-
13
00
Relay Circuit Inspection
(with the battery connected)
Battery
Meter
Meter
Connection
Reading
Connection
+
-
(0)
11 - 13
11
-
12
0
Diode Circuit Inspection
• Remove the junction box from the
motorcycle.
• Pull off the connectors from the junction
box.
• Check
conductivity
of the following pair of
terminals.
Terminals for Diode Circuit Inspection
14-12,14-15,14-16
*The resistance should be low in one direction and more
than ten times as much in the other direction
.
If any
d
iode
shows low or high in both
directions,
the diode
is defective and the junction box must be replaced.
NOTE
o
The actual meter reading varies with the meter used and
the individual diodes, but. generally
speaking,
the lower
reading
should be from zero to one half the scale.

Advertisement

Table of Contents

Comments to this Manuals

Symbols: 0
Latest comments: