Remove The Air Baffle - HP ProLiant DL385p User Manual

Secure the full-length expansion board retainer.
7.
Install the access panel (on page 25).
8.
Install the server into the rack
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Power up the server (on page 23).
12.

Remove the air baffle

CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
Power down the server (on page 23).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend or remove the server from the rack
3.
server from the
Remove the access panel (on page 25).
4.
CAUTION:
Detaching the cable causes any unsaved data in the cache module to be lost.
IMPORTANT:
board installed.
If a full-length expansion board is installed in the primary PCIe riser cage, release the expansion board
5.
retainer and remove the primary PCIe riser cage (on page 29).
("Installing the server into the
For proper cooling do not operate the server without the access panel, baffles,
rack" on page 23).
Do not detach the cable that connects the battery pack to the cache module.
It is necessary to remove the PCIe riser cage only if there is a full-length expansion
rack" on page 40).
("Remove the server from the rack" on page 24, "Extend the
Operations 34