Remove The Access Panel; Install The Access Panel - HP ProLiant DL385p User Manual

Remove the access panel

WARNING:
internal system components to cool before touching them.
CAUTION:
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
To remove the component:
Power down the server if performing a non-hot-plug installation or maintenance procedure
1.
down the
Extend the server from the rack (on page 23).
2.
Use the T-15 Torx screwdriver attached to the rear of the server to loosen the security screw on the hood
3.
latch.
Lift up on the hood latch handle, and then remove the access panel.
4.

Install the access panel

Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the
1.
rear of the server approximately 1.25 cm (0.5 in).
Push down on the hood latch. The access panel slides to a closed position.
2.
Use the T-15 Torx screwdriver attached to the rear of the server to tighten the security screw on the hood
3.
latch.
To reduce the risk of personal injury from hot surfaces, allow the drives and the
For proper cooling do not operate the server without the access panel, baffles,
server" on page 23).
("Power
Operations 25