114
Advanced features
Setting up the Network
Easy Setup using PBC (Push button configuration)
1
Press the SETUP button.
2
Select Network > Network Setup > Wireless Setup and press the
OK button
3
Press the p / q (arrow) buttons to select Easy Setup and press the
OK button.
4
Press the p / q (arrow) buttons to select PBC.
5
Press the q (arrow) button to select Start Scan, and then press the
OK button.
6
Following the on-screen instructions, push the appropriate button on
your AP.
7
When a screen reporting that "the setup has succeeded" appears,
press the OK button.
To cancel searching for the AP:
Press the BACK button while searching for the AP. A message
❖
appears. Press the t / u (arrow) buttons to select Yes, and then press
the OK button.
Easy Setup using PIN (Personal Identification Number)
1
Press the SETUP button.
2
Select Network > Network Setup > Wireless Setup and press the
OK button.
3
Press the p / q (arrow) buttons to select Easy Setup and press the
OK button.
4
Press the p / q (arrow) buttons to select PIN.
5
Press the q (arrow) button to select Start Scan, and then press the
OK button.
The Scan screen appears.
6
Enter the PIN displayed on this screen into your computer or AP.
7
Press the p / q (arrow) buttons to select the desired AP, and then
press the OK button.
NOTE
8
When a screen reporting that "the setup succeeded" appears, press
the OK button.
Check the MAC address on the label or in the manual of the AP and select
an AP.