Boot Disk Test; Auto-Configuration Process - HP ProLiant DL360e User Manual

Hp rom-based setup utility user guide
Hide thumbs Also See for ProLiant DL360e:
Table of Contents

Advertisement

Boot Disk Test

The boot disk diagnostic test verifies the presence and readiness of a primary boot controller. If a
controller is present and ready, the test checks for a valid operating system boot sector.
To run the Boot Disk diagnostic test, select Boot Disk Test from the Diagnostics Utility menu.

Auto-Configuration Process

The auto-configuration process automatically runs when you boot the server for the first time. During
the power-up sequence, in many cases the system ROM automatically configures the entire system
without needing any intervention. During this process, the ORCA Utility, in most cases, automatically
configures the array with a default setting based on the number of drives connected to the server.
Drives installed
1
2
3, 4, 5, or 6
More than 6
NOTE:
If the boot drive contains logical volumes, or if more than six drives are installed on the
system, ORCA does not automatically configure the array. If this occurs, you must run ORCA to
configure the array settings.
By default, the auto-configuration process configures the system for a default operating system. To
change any default settings in the auto-configuration process, such as the settings for language,
operating system, and primary boot controller, open the RBSU by pressing the F9 key after system
POST. After the settings are selected according to your preference, exit RBSU and reboot the server.
192 ROM-based utilities
Drives used
1
2
3, 4, 5, or 6
0
RAID level
RAID 0
RAID 1
RAID 5
None

Advertisement

Table of Contents
loading

This manual is also suitable for:

Proliant dl388eProliant dl320e

Table of Contents