Sony α NEX-3N Instruction & Operation Manual page 177

The flash does not work.
• Press the (flash pop-up) button to pop up the flash.
• You cannot use a flash with the following recording mode:
– [Bracket: Cont.]
– [Sweep Panorama]
– [Night Scene], [Hand-held Twilight] and [Anti Motion Blur] in [Scene Selection]
– Movie recording
Fuzzy white circular spots appear on images shot using the flash.
• Particles (dust, pollen, etc.) in the air reflected the flash light and appeared on the image. This is not a
malfunction.
The flash takes too long to recharge.
• The flash has been fired in succession in a short period. When the flash has been fired in succession,
the recharging process may take longer than usual to avoid overheating of the camera.
Shadows appear at the bottom of an image shot using the flash.
• When attaching a 16-50 mm/F3.5-5.6 lens (supplied), the flash may be blocked off for a wide angle.
Move the focal length of the lens slightly more to the tele side, and shoot from a distance.
The image taken with the flash is too dark.
• If the subject is beyond the flash range (the distance that the flash can reach), the pictures will be dark
because the flash light does not reach the subject. If the ISO is changed, the flash range also changes
with it.
The date and time are recorded incorrectly.
• Set the correct date and time (page 138).
• The area selected with [Area Setting] is different from the actual area. Set the actual area by selecting
MENU t [Setup] t [Area Setting].
The aperture value and/or shutter speed flashes.
• The subject is too bright or too dark, and the camera's adjustable range for the aperture value and/or
shutter speed is exceeded. Adjust the setting again.
The image is whitish (Flare).
Blurring of light appears on the image (Ghosting).
• The picture was taken under backlit conditions, and excessive light has entered the lens. When using
the zoom lens, attach a lens hood.
The corners of the picture are too dark.
• If any filter or hood is used, take it off and try shooting again. Depending on the thickness of the filter
and improper attachment of the hood, the filter or the hood may partially appear in the image. The
optical properties of some lenses may cause the periphery of the image to appear too dark (insufficient
light). You may compensate for this phenomenon with [Lens Comp.: Shading] (page 124).
GB
177
Continued r