Installing The Trusted Platform Module Board - HP ProLiant BL420c User Manual

TPM installation requires the use of drive encryption technology, such as the Microsoft Windows BitLocker
Drive Encryption feature. For more information on BitLocker, see the Microsoft website
(http://www.microsoft.com).
CAUTION:
can cause hardware damage or halt data access.
When installing or replacing a TPM, observe the following guidelines:
•
Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
•
When installing or replacing hardware, HP service providers cannot enable the TPM or the encryption
technology. For security reasons, only the customer can enable these features.
•
When returning a system board for service replacement, do not remove the TPM from the system board.
When requested, HP Service provides a TPM with the spare system board.
•
Any attempt to remove an installed TPM from the system board breaks or disfigures the TPM security
rivet. Upon locating a broken or disfigured rivet on an installed TPM, administrators should consider the
system compromised and take appropriate measures to ensure the integrity of the system data.
•
When using BitLocker, always retain the recovery key/password. The recovery key/password is
required to enter Recovery Mode after BitLocker detects a possible compromise of system integrity.
•
HP is not liable for blocked data access caused by improper TPM use. For operating instructions, see the
encryption technology feature documentation provided by the operating system.

Installing the Trusted Platform Module board

WARNING:
internal system components to cool before touching them.
Power down the server blade (on page 12).
1.
Remove the server blade (on page 13).
2.
Place the server blade on a flat, level work surface.
3.
Remove the access panel (on page 14).
4.
Disconnect the capacitor pack cabling, if connected
5.
Remove the SAS controller (on page 14).
6.
Remove the DIMM baffle (on page 16).
7.
Remove the front panel/drive cage assembly (on page 15).
8.
Locate the TPM connector
9.
CAUTION:
the TPM security rivet. Upon locating a broken or disfigured rivet on an installed TPM,
administrators should consider the system compromised and take appropriate measures to ensure
the integrity of the system data.
Always observe the guidelines in this document. Failure to follow these guidelines
To reduce the risk of personal injury from hot surfaces, allow the drives and the
("System board
Any attempt to remove an installed TPM from the system board breaks or disfigures
("FBWC capacitor pack
components" on page 8).
cabling" on page 46).
Hardware options installation 43