PS1 and PS2 Sensor Assembly Removal
Removing the PS1/PS2 Sensor Assembly
The PS1 and PS2 sensors are located under the Paper Feed
Remove the Paper Feed Assembly and place it on a flat
surface, with the MP Tray side down.
You need not remove the MP Tray from the Paper
N o t e
Feed Assembly. Use a cloth to protect the MP
Tray door from scratches.
Remove the PC Tray Pickup Roller.
Disconnect blue-wired connector on the bottom, (callout 1).
Remove the center pin from the dowel post.
Flex the right side of the Sensor Assembly to clear the locator
pin and the sensor arm from the sheet metal (see Figure 6-51
As you flex the right side of the assembly, carefully release the
(2) plastic retaining tabs on the left (Figure 6-51 callout 2).
Slide the Assembly to the right to clear the mounts.
When installing the Sensor Assembly, ensure the
N o t e
sensor flags are free through their entire range of
6-61 Removal and Replacement