Remove the Wire Harness Cover as shown in Figure 6-47.
Remove the (2) screws from the thermoswitch connector (see
Figure 6-47, callout 1).
Release the thermoswitch latch from the paper sensor flag
side of the Fuser Assembly (behind the side cover, see Figure
6-47, callout 2).
Slide the thermoswitch to the gear side of the fuser and
release it from the fuser frame (callout 3).
When installing the thermoswitch, make sure the
N o t e
sensing surface contacts the fusing roller
uniformly. If it does not, straighten the leaf
(continued on next page)
6-56 Removal and Replacement