Care And Cleaning; Adjusting The Coffee Grinder - Electrolux ICON E24CM75GSS Use And Care Manual

ADjUSTING THE CoFFEE GRINDER

The mesh of the coffee grinder blades is pre-set at the factory. Adjust the grinder
blades only if the quality of the coffee changes. The finer the coffee is ground, the
stronger it will be.
WARNING
• Coffee will pour into a cup you put under the coffee dispenser tube
during the adjustment process. To avoid burns, keep body parts and
clothing clear of the dispenser and drip tray areas.
• Do not attempt to adjust the grinder when the grinder is not on.
Damage to the grinder blades may occur.
The grinder is adjusted while it is running, using the adjustment wrench supplied
with your coffee maker.
1. Open the front panel and brewing unit doors. See page 27.
2. Install the drip tray on the floor of the brewing compartment and put a coffee
cup under the coffee dispenser.
3. Pull out the white button on the back of the front panel
4. Insert the grinder adjustment tool into the end of the grinder adjustment
screw.
5. Turn on the power switch and wait for "Machine Ready" to appear on the
display.
6. Push the Double Espresso button and turn the grinder adjustment wrench
while you hear the grinder motor running, according to the label next to it.
Stop turning it when the grinder motor stops. To continue adjusting, push the
Double Espresso button again. Experiment with the setting until the coffee
is suitable strength.
7. Remove the drip tray.
8. Close the front panel according to the
directions on page 27.

Care and Cleaning

Button
Grinder
Adjustment Tool
White Coffee
Dispenser
29