Pairing - Sony WX-GT90BT Operating Instructions Manual

Pairing

The Bluetooth device (cellular phone, audio
device, etc.) and this unit need to be
"paired" before use between each other via
the Bluetooth function.
Tips
• For details on pairing for a Bluetooth device,
refer to the operating instructions supplied with
the device.
• You can pair up to 9 Bluetooth devices with this
unit.
1
Place the Bluetooth device within 1 m
(3 ft) of this unit.
2 Press  and rotate the control
dial until "PAIRING" appears, then
press it.
The unit enters pairing standby mode.
3
Set the Bluetooth device to search for
this unit.
A list of detected devices appears in the
display of the device to be connected.
This unit is displayed as "Sony
Automotive" on the device to be
connected.
24
4
Flashing
5
• While connecting to a Bluetooth device, this
• It may take time to search or connect.
• Depending on the device, the confirmation
• The time limit for inputting the passkey differs
If passkey* input is required in the
display of the device to be connected,
input "0000."
If the device supports Bluetooth version
2.1, passkey input is not required.
* Passkey may be called "passcode," "PIN
code," "PIN number," or "Password," etc.,
depending on the device.
This unit and the Bluetooth device
memorize each other's information, and
when pairing is made,
The unit is ready for connection to the
device.
Note
If " " continues to flash, the Bluetooth
device may not be compatible with this unit.
For details on compatible devices, visit the
support site on the back cover.
Select this unit on the Bluetooth device
to be connected.
" " or " " appears when the
connection is made.
Notes
unit cannot be detected from another device.
To enable detection, enter the pairing mode and
search for this unit from another device.
display of the connection appears before
inputting the passkey.
depending on the device. If the time expires,
Input passkey
"0000"
stays lit.