Appendix. CRU instructions
Note:
The illustrations used in this appendix are for the Lenovo IdeaPad Y500, unless otherwise stated.
•
•
The following steps about upgrading and replacing devices are the same for the Y400 and Y500.
Make sure the battery has been removed before replacing any devices.
•
Replacing the battery
Note: Use only the battery provided by Lenovo. Any other battery could ignite or explode.
To replace the battery, do the following:
1
Turn off the computer. Disconnect the AC adapter and all cables from the computer.
2
Close the computer display, and turn the computer over.
3
Unlock the manual battery latch
unlocked position
4
Install a fully charged battery.
5
Slide the manual battery latch to the locked position.
6
Turn the computer over again.
7
Connect the AC adapter and the cables to the computer.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
b
, remove the battery pack in the direction shown by the arrow
a
a
. Holding the spring-loaded battery latch in the
c
b
c
.
31